Recent content by gnome

  1. G

    Re-setting fuel

    Hiya buddy, I tried holding the button in and it didnt work. It could be an ECU setting which my bike doesn't have - I run a GSX1400 with SuperCharger which I have fitted a set of 220 Busa clocks to. Thanks for your help anyway .GNOME.
  2. G

    Re-setting fuel

    It actually reads "miles/l" That bit I can live with, the main problem is re-setting it as I said "it reads - 50.0 miles/l" I have tried re-calibrating, and all that did was reset the stepper motors. I have tried just about every combination of button pushing and still it reads the same. At...
  3. G

    Re-setting fuel

    Evening all from the not so sunny UK. Quick question if I may - on the trip you have miles / trip 1 / miles per ltr etc etc Is there anyway to (a) change it to miles per gallon (b) re-set it as mine says that I'm doing 50miles to the ltr (I wish) Thanks guys - ohh and Happy Easter to all you...
  4. G

    URGENT help needed

    I like you, your silly I would say "race ya" but your a little too far away. Thanks again for the help. .GNOME.
  5. G

    URGENT help needed

    Did think of that, the problem is the wiring for the temp sender goes via the ECU, it's not a seperate unit and I'm no where near clever enough to start playing with that little box of electrical magic. I know it's only full of smoke cos if you mess up it lets out little puffs of the stuff...
  6. G

    URGENT help needed

    Sorted eventually, to anyone doing a loom swap BEWARE - the colours on the speedo plug are NOT the same on the 04 model as the previous years, found this out with Nath's wiring above, had to source an earlier plug layout to rectify 2 missplaced wires. But the good news is it works a treat. So...
  7. G

    URGENT help needed

    Thank you sir, it's a different set up to the 14. I will give it a go in the morning. Thanks again and I will post up tomorrow when I get home (short 300 mile trip home in the freezing rain - cant wait lol) .GNOME.
  8. G

    URGENT help needed

    What a nightmare job - getting the busa clocks to work on gsx1400. . . All done fitted and working (except for the temp gauge - the 14 is air cooled) One last favour / question if I may. . . . PLEASE how do you reset trip 1 & 2, thanks in advance .GNOME. PS: will sort out photos soon
  9. G

    URGENT help needed

    THANK YOU THANK YOU THANK YOU THANK YOU and in case you missed it - THANK YOU .GNOME.
  10. G

    URGENT help needed

    PLEASE. . . . . Someone must be able to help
  11. G

    URGENT help needed

    Morning from the UK. PLEASE if someone has there speedo / tacho pod unplugged could you take a close up photo of the plug, or let me know the order / colour of the wires i.e. looking at the plug from the clip side - left to right = red, black+yellow etc etc. They cheeky bit - if someone can do...
  12. G

    Clocks question

    Brilliant, just what I needed, I will be attempting to re-wire and fit the clocks to the 14 next weekend. I will of course drop in with a photo or two when it's complete. Thanks for all the help guys .GNOME.
  13. G

    Clocks question

    charlesbusa sir, are you still going to be able to send me a couple of photo's? need to be 100% sure before I try and fit a set. Thanks again .GNOME. E-mail address
  14. G

    Tsunami death toll is huge!

    And you guys voted Bush back in. . . . yep there will be a rise in WorldWide deaths. .GNOME.
  15. G

    Clocks question

    You are correct sir, they are the new BlueFlame 'Evo' cans, I opted for the 400mm insted of the standard 450mm as I think the shorter ones look nicer, and they work very well with the charger i.e. no burning and good gas expulsion. They did have problems with some of there earlier cans blowing...
Back
Top