KhandyRhedBhusa
Registered
Hello I wanted to post here since i cant post a picture in PM
But Mr Bogus was helping me, and with his help i got the sprocket cover
off.
now i fail to see the parts that need to be replaced once the cover is off lol
my guess is that it fell out?
i have a little leak, that over time got to this, worse. no pressure.
In my mind, here is how i would replace.
Clean the slave housing. Clean the piston (long shaft by chain)
from the kit i would
1. put in the spring like ice cream cone
2. put in the disk with center hole
3. put the ring cap over it all
is this correct ?
But Mr Bogus was helping me, and with his help i got the sprocket cover
off.
now i fail to see the parts that need to be replaced once the cover is off lol
my guess is that it fell out?
i have a little leak, that over time got to this, worse. no pressure.
In my mind, here is how i would replace.
Clean the slave housing. Clean the piston (long shaft by chain)
from the kit i would
1. put in the spring like ice cream cone
2. put in the disk with center hole
3. put the ring cap over it all
is this correct ?
Last edited: