Okay, I know this should go under "Top Speed", but not too many people look there so I figured I would get better traffic under this forum.
Unlike the Gen I bikes, the Gen II's do not have cotter pins on the rear axle nut. I am getting the bike ready for racing in the Texas Mile and of course one of the safety requirements is, "Rear Axels must have cotter pin, clip, or safety wire to retain nut in place".
So what are you guys doing or what have you done for the rear axle nut?
Thanks,
Joe
Unlike the Gen I bikes, the Gen II's do not have cotter pins on the rear axle nut. I am getting the bike ready for racing in the Texas Mile and of course one of the safety requirements is, "Rear Axels must have cotter pin, clip, or safety wire to retain nut in place".
So what are you guys doing or what have you done for the rear axle nut?
Thanks,
Joe