I just installed a Brock's Exhaust, but it is touching the plastics right under the foot peg. Is this OK? Or should I cut the plastic so it doesn't touch anymore?
The tape is a good idea. I have a Tsukigi 4 into 1 exhaust on my '07 and it has worked it's way through on the right side. I heat shielded as best as I could but the fit is real tight for about 6 inches. It runs very close for about 6 inches there. It has melted through for about the same length on my bottom right fairing to just before the bolt that secures that section. Even with what I could fit between the fairing and the pipe shield wise it came through. I run the bike pretty hard so for a casual rider it may not be an issue but how many casual 'Busa riders consider themselves in that "casual" spectrum? Anyway...I buzzed out a slot that frees up the pipe and allows air flow between the pipe and lower fairing ( after the melt through ) that still allows the securing bolt to keep things from flapping in the wind.
mine melted right through. didnt know it was touching. i got the stainless steel. wish brock could do something about that. seems like a flaw but what do i know
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.