How to mount Gear indicator

Discussion in 'Electrical Mods' started by Mikael H, May 1, 2010.

  1. Mikael H

    Mikael H Registered

    Contests won:
    0
    Messages:
    239
    How do you mount your gearindicator above the speedo?
    Do you make a bracket or??
    Thank´s.
    Mikael
     
  2. twotonevert

    twotonevert Member of P.E.A. Moderator Donating Member Registered

    Contests won:
    0
    Messages:
    25,933
    Location:
    Tehachapi CA
    Some folks have made brackets, I ran the wire behind the gauge cluster and put a little piece of Velcro at the point the gear indicator touches the windscreen. Hasnt moved in over 5000 miles.
     
  3. DEMMYM

    DEMMYM Donating Member Registered

    Contests won:
    0
    Messages:
    8,426
    Location:
    WAGONER OKLA.
    +1000


    ==========================================================

    000_2826.jpg
     
  4. Mikael H

    Mikael H Registered

    Contests won:
    0
    Messages:
    239
    ok, thank you!
    To run the wire behind the gauge cluster, how much do I need to remove?
    Mikael
     
  5. BlueHaya

    BlueHaya I'm outta here!!!! Donating Member Registered

    Contests won:
    0
    Messages:
    13,306
    Location:
    Texas

    +1 ::4

    GiPro 001.jpg

    GiPro 002.jpg
     
  6. twotonevert

    twotonevert Member of P.E.A. Moderator Donating Member Registered

    Contests won:
    0
    Messages:
    25,933
    Location:
    Tehachapi CA
    Remove the wind screen, the inner panel on the left side, and the gauge cluster. Run all of your wiring and put the Gipro wire behind the cluster and put it back. Be careful removing the cluster, you will have two bolts to remove and there will be 2 plastic tabs that go into a rubber grommet, put out slowly and in a straight line, you dont want to break one. Once you put the cluster back in place, it will hold the Gipro in place for the most part, the velcro is just to make sure it does not vibrate around.
     
  7. Mikael H

    Mikael H Registered

    Contests won:
    0
    Messages:
    239
    I will give it a try, Thank you!
    Mikael.
     
  8. Mikael H

    Mikael H Registered

    Contests won:
    0
    Messages:
    239
    I have just mounted my gear indicator, no problem :)
    Do you put a fuse on the red wire by the battery?
    Mikael.
     
  9. pashnit

    pashnit Site Sponsor Registered

    Contests won:
    0
    Messages:
    8,308
    Location:
    NorCal
  10. Mikael H

    Mikael H Registered

    Contests won:
    0
    Messages:
    239
    Thank´s :)
    Do you put a fuse on the red wire by the battery?
    Mikael.
     
  11. Rhythm

    Rhythm http://www.youtube.com/us Donating Member Registered

    Contests won:
    0
    Messages:
    7,385
    Location:
    Col,OH
    Custom molded mine and covered with a carbon fiber vinyl.

    [​IMG]

    [​IMG]
     

Share This Page