Hello folks,
Any sponsors of this forum sell the Genmar riser blocks? I'd like to install a 3/4" tall block on my GenII Busa. I am hoping the stock length front brake lines will work since I just installed a new set of braided stainless steel lines. Thanks!
Jim
I don't see it listed anywhere...
Thanks, but I was referring to the 3/4" Genmar on Powerhouse.
I have the 1 1/4 gemar riser and the stock length lines still fit, But just barely. When I change to Steele braided I will get another 2 inches for good measure.
The brake reservoir contacted the windshield at lock. But the clutch cleared it just fine. I noticed the brake reservoir was set further out from the factory. Not sure why. Just watch your clearances before you mark your wind screen. Even if you do you won't see it when in your tuck.
This issue only occurs with the 1 1/4" riser. The 3/4" version has no clearance issues whatsoever, no issues with the stock length lines or cables. . .