Fitting a Tail Tidy - Gen II

[Katana750]

Hey guys, trying to fit my new tail tidy to my 2015 Gen II. I've got the rear section off, however how do I remove the rear bulb housing from the smaller tail light/number plate light..?? There're a couple of small screws in the rear of the small tail light, however I'm not thinking that's the case...?
See the two pics attached..
Cheers

 

[Mythos]

It looks like you have it unfastened. Follow the wire back to the main harness, there is a white connector that you can unclip. The wire and the clip should pull through that hole in the stock rear fender. I never took the light off. I just took the whole fender off and used lightbolts to light my license plate. The lightbolts were hooked up to the same power source as the stock tag light.

 

[SSGT_B]

Wow I read the title wrong. Time to use my glasses. I read, finally a t1tty.

Must have coffee, and pie

 

[Katana750]

Thanks Mythos, sounds like you're on the money... My tail tidy came with an LED lighting tube so presumably it'll just click into the same white plug you refer to..
Cheers from Aus...

 

[Katana750]

Sorry SSGT_B, didn't mean to give you trhe wrong message mate.. lol Always up for a coffee and pie...
Though in Aus at the moment it's hot - so beers are preferred mate..