drag only wiring diagram?

[aaronxs400]

anyone have a stripped down wiring harness for a hayabusa? My motor is getting transplanted into a chrome moly drag chassis and i will need to disable the safety sensors. I also need to know what to disable to run a tach only.

i heard you need some resistors for the tip over switch and side stand switch. would anyone know these values?

[Commuta_Busa]

The sidestand safety switch can be hardwirred but you're right about the tipover, it needs some resistance. I just left mine on but if no one chimes in today I can measure it tonight and report back. Those two sensors are the only two safety ones I can think of that can be dissabled/bypassed to start and run the engine.


There are lots of wires that can be tossed for a drag only harness. Do you plan on keeping the ecu in the OE location? IF you move it to the front you can shorten alot of wires and just extend some that go to the sensors. A custom harness is alot of time consuming work. I thought about offering one but not yet. It would be a complete new harness assembly.

[aaronxs400]

will be laying out the bike this week, not sure where the ecu will go.

[onetime468]

i know this is old but does anyone have some insight into this>?? jfgoddard09@gmail.com