Recent content by Tolarian Academy

It’s alive! Got the old hack job hid ballast and associated wiring removed and Sylvania silver star in, a previous owner lost or threw away the bulb adapter and rubber surround for the headlight so I had to cut the end off of part of the hid wiring and crimp on some heat shrink female spade ends...

Oil changed and clutch swapped, the old friction plates definitely had some heat stress and the friction pads themselves looked around half worn down compared to the new ones, hard to eyeball something that thin though, the new springs were also a little bit taller than the old ones, so all in...

Finally have enough time to start the tear down to change the clutch and pulled the gauge cluster to see everything better, I do have a hid low beam conversion and it appears that maybe the bulb is now burnt out as the center circle inside the tube is cloudy and wiggling any of the wires didn’t...

Thanks for the insights, looks like I'll be counting sprocket teeth and see what I have, I also already have an outlaw kevlar impregnated clutch upgrade(friction plates and springs included too), so it's getting a new clutch. I just ordered a set of cheap amazon front and rear bike lifts, so we...

I'll look into one after I get the bike back riding, I can live with guessing and going with traffic to get close enough to the speed limit, I live in a rural area so I will be mostly small town and highway riding anyway.

Hello everyone, newish busa owner here, I bought it last summer and rode it a few times, it has a couple issues so it’s sat mostly. I figured I would start a thread to say hello and record my progress troubleshooting/fixing it’s issues. 2000 Hayabusa with full Akrapovic exhaust, Power commander...