Recent content by scorpionreptyle

speedo and odo LCD are of no use,everything else works normal. i`ve unpluged both hid ballasts and nothing. Speedo sensor is working,i hook up a HUD to it and is working. I will try with an electronist to see if something "light" his eye on mainboard. :(

I let her stay over night without battery,checked all the wires and connections,tested speed sensor on a HUD and worked fine. Everything is fine,except my clusters. They are the problem,i have to open them and find fried diodes/circuits . Cause = intermittent contact in HID ballasts. ....my...

Taking into consideration that by mistake I interchanged + and - of the HID ....any bad consequences ?

combination is : select button pressed------switch contact on--wait for 3~5 sec----release select button and then press it twice (all the procedure must be done in under 10 sec) I discovered last night in the manual,but I`m not with the bike for now,tomorrow I will try all options...

Thanks man! I`ll try to disconnect the battery over the night to see if something happen,then I`ll come back with result!

Hello guys! Few days ago i encountered a problem with my `99 busa. I decided to remove the TRE installed by myself half a year ago. Everything was perfectly fine in removing and assembling of the TRE and original OEM GPS harness,but after I start the bike, 2nd LCD where total mileage,trips...

sorry to interfere ,but how somme of u guys tells to an inexperienced biker to fully engage rear brake in a such of circumstance ( emergency brake - that is supposed to be at enough speed,otherwise it is not an emergency). Plus you encourage him to keep rear brake locked if this happen ?!! High...