Recent content by R-III-R Turbo

  1. R-III-R Turbo

    Replacing head gasket, anyone know what parts needed (besides head gasket)?

    Ok so finally got some time off work to go ahead and tackle this. I bought the bike used in 2015, started and ran well, performed as good as any stock gen 1, but doing a compression test for the fun revealed a 160ish psi across all 4 condition. Spec was 171 - 228psi, service limit 128psi. I...
  2. R-III-R Turbo

    Replacing head gasket, anyone know what parts needed (besides head gasket)?

    Yeah I was surprised, hoped I forgot to open the throttle or something, but no, photographic evidence shows they were wide.
  3. R-III-R Turbo

    Replacing head gasket, anyone know what parts needed (besides head gasket)?

    Cranking compression results were 142psi on 1, 152 on 2, 147 on 3, and 150 on 4. Squirting a drop of oil into the cylinder brought compression up by about 10psi. So not a massive jump, could well be rings but not entirely certain. Last compression check was 46K miles, they were all around...
  4. R-III-R Turbo

    Replacing head gasket, anyone know what parts needed (besides head gasket)?

    Hi guys, newbie 'ere. My bikes are a Rocket III and a 2004 Busa. The Busa has become increasingly hard to start, this is due to low compression. So I am going ripping the head off to investigate. BTW clearances were checked too all good. Just to save me bother, has anyone who's had the head off...
Back
Top