Recent content by mitrls10

Mentally I'm fine I've got up to bout 190mph but it is a rough ride and the forks were setup for the track so it is kinda rough and makes me sore lol.

I can never get pics to post right on here but I finished my bike and painted it pics are on photobucket, myspace, or facebook. mitrls10 (torqued motorsports). Its house of kolor Trublue pearl..

Thanks everyone for the help, I got it fixed today. I got a service manual from my local shop today and actually worked on the bike in the daylight, and was tracing through wiring diagrams and noticed the turn signal relay was missing. Looked further at the wiring diagram and part of the...

I never have luck posting pics this insert image thing dont work for me lol. Plus nothing special I just have all the bodywork off now.

I have only 1 picture of it before the wreck but a bunch after lol..

Its in neutral but the indicator light isnt on, on the cluster. I done all the rest but it still has no starter-wont even spin, fuel-pump wont prime or run, or spark-power commander lights wont come on.. Guess I'm going to have to get a wiring diagram and start tracing wires..

This thing is getting on my nerves. I checked the black/tan wire and for a second it showed a short to ground then I checked it again and it didn't. errrr.. But when it wasn't showing a short to ground it still wouldn't do anything.. I jumped the starter and the motor isnt locked up but...

is there like a flow chart or step by step procedure in that book bluehaya?? If so does it say to check if the voltages are not correct?

I just wanted to get a cluster to monitor coolant temp oil temp and all that. I didn't know it would run without them though I figured the gauges would have to be hooked up cause on most cars they require that for the oil switch or it will show no oil pressure and shut off the fuel.. Learn...

I love doing electrical work thats alot of what I do at work and all the hard diagnostic work that other shops cant figure out but I'm a car guy not a bike guy lol I know this is a pain for you but thanks alot bluehaya you are the man!

Thanks every1. 61.5k ohms upright or horizontal Voltage is .095 upright or horizontal so I checked each wire individually off the battery and both of them only get voltage when I touch positive side so its like they are both grounded or just not getting voltage at all.

how much resistance is it supposed to have? I can prob go get a ohmeter from someone real quick.

K I've unplugged the to sensor and tried to crank it still nothing, got a paperclip and touched the 2 wires together on the harness side still nothing..

It might be a brown its really hard to tell in the dark with a light on but where is the relay it goes to? Also the lights on the power commander dont even come on when the ignition is turned on. All the fuses I can see are good as well. There is a fuse panel with 8 fuses then one on...

I cant remember if it does this or not when you first turn the key on before cranking but the gauge digital display says chek