Recent content by Lord T

Re: MY BUSA SPUTTERS, HELP!! I'm having this same problem with my 05 except it kicks out and stutters at 2300 rpm.... And in every gear.. Any ideas

What size link chain do you need for the back chain on a300 swingarm streched +4

Is it necessary to remove the oil to remove the righ side engine cover on 05 hayabusa

What metal is a gen I (05) busa rim made of

When I said no exhaust I ment I have nothing on but just the headers no mid pipe or cans

im goin to start over... I have 2005 hayabusa with 43k on it.... I have a small airbox mod, a pcIII with a race exaust map, running no pipes or tips, a bmc race filter, plus 2 on the back sprocket, modded the airbox sensor into ram air duck, a tre, and a speedohealer... a few months ago my...

Would the fact that I run no muffler with basically a pcIII mapped For a race exaust have anything to do with stutter

Changed plugs synced tbs aligned tps still no cigar.. Bike still stutter at around 3k and struggles to pull past that

I have an 05 hayabusa... With a tre, small airbox mod, power com, and -1 on the front sprocket. My bike has started to stutter. If I hold the throttle at about 2900 rpm the the pike surges and sputters. If I accelerate from idling and let out the clutch after reck 2900 rpm the bike drops back to...

I have a 2005 hayabusa which runs fine. When I realy get on the throttle to high rpms the bike then flashes f1 but still runs. If I keep shifting at high rpms the bike has this stutter feeling like its losing a little power but at low or mid rpm it's fine. When I say i mean around 8 to 11k rpm...

If u have this part can u txt 912- 341-7160

????? Just txt 912-341-7160 if u do

Ok I need a lil help I think I may ha e found da problem which goes bak to me dropping da bike on it's left side... I found out the crank sensor wasn't getin enough voltage and that it was u der the stator cover... Took the cover of and saw a bunch of shredded metal and two of the bolts that...

It's the crank señsor which is located under da stator cover too... And I downloaded da manual only 18 pages

Does neon have a diagram on how to put on the stator correct or can explain