Recent content by kleckbusa

from the back

i started with one beer and started cutting the faring. A few minutes later i cut more than finally got rid of the whole thing

try this

green bug got mine.

I painted with raddle can

Yea been wondering about the front end myself. Looks like a bird on steroids.

try this side

Buy the mid pipes off of ebay for about 50 bucks. Cut them in half at the weld line and add a few pieces of exhaust. I spend 100 buck for mini mufflers to sit inside the end pieces and got the adapter from autozone for 3 bucks a piece. Sound like a nasty raw motor ready to do bad things without...

Put tre on and don't have to worry about lean. Never had a dyno and will never have one. Dyno numbers are bs except to impress. Just ride.

I got mine for 60 bucks each. Sounds better than anything for more money.

Don't have much to list.

Shop is full of crap. The ecu has fuel maps for each gear. The TRE puts the map in its 5th gear map which is the nicest fuel mixture map. I have it. At idle the bike will run cooler because it is getting richer fuel on idle and all the other gears.

Put mine between the intake ducts. Cut the bottom plastic so the bottom of the horn sticks out. Pick up the bottom faring piece from ebay for pennies. I had to get a support between the intake ducts. But you can figure that out.

**** get some WD40 to soak the paper and than go to office depot and get some pink erasers. Start rubbing with the erasers.

more nasty green