Recent content by Jdavila661

You can remove the cover with the four screws holding it in. You'll expose the front sprocket and the push rod that goes into the case through a rubber seal. Hopefully it's not that seal that is leaking...

dammit Ibondoman, why couldn't you be in the bay are, I would've jumped on that price! :banghead:

I was really apprehensive on doing it. I saw a post using this approach and he reported it 5000 miles in, still holding. the cheapest quote I got was $2500 at a shop around here. I just paid $4700 for the bike 3 weeks ago so I wasn't about to drop an additional lump sum...I couldn't. :11doh...

sorry for the delay guys, I was busy with the pushrod seal replacement....got it in without splitting the case!! Took about 4 hours, mainly cleaning out the gunk that the previous owner used with hondabond. The guy have replaced the seal, but used a different one with no metal insert and glued...

With the bike running, it registers at 13.6v @ 5000rmp.

I have this problem, when the bike is warm, it won't start. You added a wire from battery to starter solenoid?

At first that's what I thought cause I got it at walmart, so I went to cycle gear and got the oem replacement, no go, then I upgraded to the heavy duty version, still same. Drove it last night when I tested voltage. This morning, fired right up, voltage stays at 12 during firing right now

At first that's what I thought cause I got it at walmart, so I went to cycle gear and got the oem replacement, no go, then I upgraded to the heavy duty version, still same. Drove it last night when I tested voltage. This morning, fired right up, voltage stays at 12 during firing right now

It is a new battery! Lol, I've replaced it 4 times already. Properly charged, checked rectifier, I'm stuck

So the oil thing worked by running a thicker weight like some suggested, not completely stopped but reduced, that's my winter project. Back to the original post: I ran a thicker power and grounded the starter as suggested. After a ride, the battery registers at 12.8v when off. When I try to...

Is that what that stuff is?? I thought that hardened piece on outside was aftermarket. I took a while looking for the replacement seal because everything I saw didn't have that outside coating. PISSES me off that this guy sold me a problem bike :newburn: !!!

ok, I'll try that, thanks, the leak is pretty bad, [/URL][/IMG] [/URL][/IMG]

what key words should I search??

I live in norther cal, near san francisco

what was the outcome of this repair?? I just bought a busa and found this same seal cracked. Just ordered it but am dreading the repair...