Hey all,
A update regarding the concern :
Exact issue : when engine is running cold charging voltage is maintained at 14.2V at idle, when engine reaches 100*C, both fans turn ON, it is clearly visible that headlight got dim and severe load on bike electrical system. Charging voltage drops...
Yes I had changed reg/rect with OEM in Aug month this year along with new battery.
Yes in India temp. Is around 35~40 degree
Just need to know whether stator is ok or not
Answer :
Stator is not replaced only connector (male/female) replaced with new one. Reg/rect is new OEM (suzuki)
Melted connector replaced
No damages on rotor assy.
55~65V at 5K rpm
Continuity not checked from stator connector plug to reg/rect.
will verify again with another multimeter.
Hey all
This is my 2nd post regarding long unresolved issue I am facing in my 2011 Gen II hayabusa.
In my last post, regulator & rectifier unit is found to faulty as stator coupler is melted. Hence it was replaced along with new battery (YTZ14S).
last week I had noticed :
1. When engine is...
Hey folks
I had encountered with battery voltage drain issue.
Last weekend riding back to home, i just stopped for refueling, while cranking the engine i had observed that engine hard/struggle to start. Secondly instrumental cluster also reset without switching OFF the ignition. Engine was...
Hey ALL!!!!!!!!!!!!!!!!
Wishing you all happy new year !!!!!!!!!!!!!!!
HELP!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
I am facing a problem with 2008 hayabusa:
1. Code C:40
2. Code C:28
3. Engine rpm is raise to 2000 and fluctuating between 2500-1000. Video is...
Being a 2011 model, overhauling of steering stem is required. But busa has specialized nut to remove the steering stem.
Procedure as follows:
1. Remove/lift fuel tank
2. loosen steering assy. top nut (golden one), 32MM loosen wheel assy. RH pinch first then axle nut. loosen LH pinch bolts.
3...
Brother reason for this failure is that vehicle was kept idle at one place for long period of time. I am 2nd owner. This bike belongs a celebrity (Cricketer). Fuel decomposed overtime and results rusting!!!!!!!!!!!!!!!
As per my previous thread regarding Hayabusa not accelerating beyond 160KMPH. On further inspection of vehicle few abnormalities were observed:
1 Fuel Strainer: On disassembly of Fuel pump, rust is observed on fuel strainer which leads to blockage of strainer, filtering membrane of strainer is...
Dear All
Please help me out what is the procedure of tightening of Taper Roller bearing in GEN II.
It will differ from ball bearing tightening procedure. PLEASE GUIDE.
Brother i have a query regarding this post
Ball bearing outer race have same dimensions as of frame assy,
but tapered roller bearing router race is bigger in size when compared with ball bearing outer race. How it can be fitted in frame ??????????????????????????
please let me know...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.