I am located 15010 N Cave creek road Phoenix Az 85032 My shop is "Dwn N Out Motorcycles"...
I ran the car out to Glamis this weekend and it ran perfect.....I still never could find an exact answer for what are all the triggers to make the secondary fuel injectors fire. It is now obviously...
FIXED......
Just wanted to update that I got this fixed. It ended up being the Crank position sensor. This is the sensor that comes with the stator from Suzuki. They do not sell the sensor separate. If did not think it was due to the fact I had no codes and if I unplugged it the motor...
Thank you for taking the time to help. I am located in Phoenix Arizona. I own a small motorcycle dealership called "Dwn N Out" (Just got google 360 photos done).. So I would not say I am an expert but I do have some experience around motorcycle's. This is one reason this is pissing me off...
I agree it is weird....I am hoping to find out what the factory parameters are exactly. If it is rpm based, pressure based, do they have to be in gear, does it require to be above certain temp, Voltage or a combination of a few of these things. It has worked for the past 5 year than...
All 8 injectors have the 12v on the yellow wire. I pulled the Power commander stuff off and the ecu does not sending the ground signal for the 4 secondary injectors. Pin 61,62,63,64... ?? Something is telling the ecu not to send the signal. ??Safe mode of some kind??
I am trying to find out exactly what triggers the ecu to send the signal to the secondary fuel injectors?
Here is what has brought me to this question. I built a Turbo hayabusa (gen 2) 5 years ago. I run the Power commander v-pti, power commander Ignition, Power commander secondary fuel...
Am I getting this backwords? I seen the robinson gear and I thought it was to increase mph in 1st gear?? I need lower speed.
This is the discription they list on their website "Replacing the 1st driven gear only with the Robinson industries 1st gear will lower the ratio from 2.61:1 to...
I am putting together my second turbo hayabusa powered sand rail. The first one we did runs great the only complaint I have is 1st gear starting off. I have played with smaller front sprockets and larger rear sprockets. I want to see about getting more 1st gear torque out of the...
I have a 2006 with 8k miles on it and same thing...I pulled the engine tonight and now trying to get the transmission out the bottom....I am stuck have you seen any good instructions for removal via the bottom? The service manual talks only about tearing from top to bottom.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.