Recent content by ej2006busa

I made my own block off plates by cutting the hoses off welding the little holes shut and bolting them right back on... plugging the where the lines went.

Yeah I'm glad too. Guess it just took a shop that knows what they're doing.

Hey the busa is fixed! It did end up being the wheels being out of balance. I found a place in Miami that was able to high-speed balance them and I finally got to take it for a test drive a couple days ago and she's smooth at all speeds! Just wanted to thank you guys for the info. The rear tire...

I'm not sure about the damper I've checked it visually and there's no oil around the ends but other than that I really don't know how to tell if it's working correctly. Although I have been wanting an aftermarket one As soon as I get some more money lol.

True that's a good idea

Well I have had two different people balance the tires the weights that flew off might have been partially my fault because I told him to stick them in the center of the rim for cosmetic reasons but in the center of the rim the weight can't be glued flat against the rim only about half of the...

Yeah when I Static balanced the tires we broke The bead and sucked out all the beads that were in it

Yeah I'm going to call around tomorrow to find out if anybody can high-speed balance the tires. I used to have Dyna beads in them and I took them out because the people from dyna bead told me that if there was any other problem with the bike like bearings etc. that Dyna beads well actually Make...

Thanks for the reply guys. You can take your hands off of the handlebars at pretty much any speed below 90 and it tracks straight, smooth, and no wobble. I've only got one dealership close by but Ill try and call a few other ones are little bit farther away to see if anybody high-speed...

Yeah I've also exceeded my knowledge on the subject to apparently! Well currently my tires are static balanced because the dealership down here doesn't seem to do high-speed balancing I'm guessing about 30 miles an hour plus I don't know when the last time they had their machine calibrated so...

Well I havent posted much to this forum because she has been running pretty well... except for a shaking that I cant get rid of! I guess I'll start with the problem. The bike has 30k miles Ive had it for 20k. Below 100 the bike runs smooth with no problems. But as soon as you start to cruise...

Well I tested the sensor and it does seem to be bad so I have one on the way. Does anyone know if I will have to bleed the system when I replace it?

alright cool thanks. I've got to look into finding someone around here that can tune it. I live in the Fla. Keys so that might be a challenge.

Hey man thanks for the link to the service manual that's awesome and should help out a lot. And I'm going to go try jumping the sensor now. Thanks for the replys guys!

Hello, I was wanting to do this to my bike. But before I do I was wanting to know if anyones had a chance to run the bike at top end. Someone on here mentioned that low and mid range was better but top end was worst. Anyone have any info about that, or any other negitive effects by doing this...