Recent content by deeman

what's up riders!!!! Had a problem with the bike giving me a F I light code 32,33,34,35 jumped the wires checked ( injector, wires harness for in jectors, checked for loose wire, and the ECU ( I think I did it right the ECU kinda had trouble confused a little) for consist, resis , and volt...

07 busa given me codes, jump the code and c32 c33 c34 c35 came up!!!:please::please::banghead:

where should I look for that!!!!!!!!!!!!

finaly found out what was the code when my f I light cames on the codes are 32,33,34,35 which are codes for the ignition system malfuction( the emc does not receive a proper signal from the fuel injector, faulty fuel injector, wiring or connector. Faulty power supply to the injector. "That is...

thanks will get a battery in the morning, and i will read how to set the idle seed tonight. Will let you know Mike 1180 thanks for the repley!!!!!!!

sorry to get back so late, but one of my fellow rider die!!!!! took me a while to get back on the back, thank for the help with my bike. I took the bike on yesterday and it was doing fine but started cutting of when coming to stops. while on the way home cruzing about 90 mph the bike just...

rode the bike after re-maping, and used some sea-foam for the injectors. no fI code, Good power , and didn't so far didn't ride a long time. Will get up in the morning and put it to the test. Will keep you posted! Thanks again!!!!!!:thumbsup:

just re-map the bike can't test now it's 15 degs out hope to let you now soon!!!!! Thanks for the quick anwser:thumbsup:

Thank it took a while but someone help me once again!! Will try to re-map the PCIII disk when it get home. how do you get the F1 light to turn off!!!!!!!!!!!11

did you fine out what was the matter, i have the same problem. can you help me out!!!!!!!!!!!!!!!!!!!!11

I have a 2007 busa Yosh pip, PCIII, pair valve mod ( marble) thanks to Hayabusa.org Having probles w/ F1 code pops on when excel over 100 mph. F1 code flashs but the bike still is workin fine, but cuts off sometimes when coming to a stop! This doesn't happens all the time Cranks backup and...

Thank I fix It!!!!!!

Thanks guys for the quick reply, I pushed the cartridge but it do any thing. What i did was i went to home depot, got a 1 1/2 " pvc pipe cut it to about 3 feet long, stuck the pipe into the cartrige side, turn the fork over where the cartrige bolt would face me, put pressure on the fork ( which...

will try that when i get it back to house!!!!!!!!!! Thank I hope this works!!!:please:

need help / w removing the bolt out of the bottom to the fork, it's just spinning. tried to put air on the bottom but bolt keep turning. made all the repairs 2 the seal but can't get the bolt to tighten!!!!!!