Recent content by BusaBenny

Hello. How many full turns is equal to one line on the preload adjuster? For example. From fully seating and I want to have three lines showing, how how turns counterclockwise do I have to go? TIA

I went with just the MC as I find the clutch to be ok for me. I typically bleed them the way you mentioned, as that’s how I did it when I install the core ss lines. I’m curious as I didn’t research the clutch upgrade, What are your thoughts on upgrading the clutch mc?

Thank you guys for your replies. I went with the rcs19 mc.

that’s what I’ve been reading. Thank you.

Hello everyone, What are my options for a front mc upgrade? I only street ride. I have upgraded my lines to core ss. I was wondering two options: 1. What Brembo mc is a good option? 2. What other manufacturers/models/etc is a good option? TIA

Thank you sir for your help. I followed your directions and I believe I found the air pocket. When I cracked the abs line to the front calipers I feel like I got a lot of air. I bleed and cracked it three times. Then left them strapped over night, bleed them again and they are great now. Thanks...

Awesome write up thank you. I think my issue is like what you said. The air is moving from the abs to the MC. I will try your process and update you.

Oh somehow I missed the notification for it. I just replied. Thanks

Would I be able to use that tool to bleed my abs unit on my 2017 abs model busa? And if so can you provide me a link to the jdiag? Thanks.

Good afternoon everyone. I have searched the web high and low and I have not found an answer to my question. I have bled my brakes and I believe I have air somewhere and I think it’s the ABS unit itself. So how do I activate the unit to get the possible air out? I know I can do it while riding...

Do you have a link to it? Thanks

A little late on this reply but can you elaborate on the issue you are talking about? Are you saying the abs will or can get stuck in an odd position and it won’t bleed probably with the bike off? I have always bled the bike when it was off.

So i have the harbor freight vacuum bleeder and it works great. I’m just thinking about using both to make sure one hundred percent I have it bled.

Hello everyone. 2018 gen2. I was wondering if I make a retrofit pressure bleeder for the brakes and clutch bleeding process, if it would be ok to use? I know for my bmw I have one that is safe to use up to 10psi. If it is ok, does anyone know the max psi ? I’m talking about the bleeders that...

Go onto Amazon and eBay. Find a similar one and see if they have a picture of a wire diagram. Sometimes in the pictures they have one. Then see if you have the same colored wires.