Greetings!
I'm doing a RCC stage 1 install on my gen-2. I have my motor out for a transmission issue, so I figured now might be a good time to build the motor a bit. My power goals are 250-280 hp range (6-8 psi boost). I am planning cylinder head studs, valve springs and turbo pistons. Should I be looking into stainless steel valves as well or is what I have planned enough for my power/boost goals? Any other mods? And forgive me if this is a dumb question but when valves are mentioned are they talking about intake valves, exhaust valves or both?
thanks!
I'm doing a RCC stage 1 install on my gen-2. I have my motor out for a transmission issue, so I figured now might be a good time to build the motor a bit. My power goals are 250-280 hp range (6-8 psi boost). I am planning cylinder head studs, valve springs and turbo pistons. Should I be looking into stainless steel valves as well or is what I have planned enough for my power/boost goals? Any other mods? And forgive me if this is a dumb question but when valves are mentioned are they talking about intake valves, exhaust valves or both?
thanks!