Well it took 9 weeks to get my kit and then another 2 to get my two stage boost controller which was ordered at the same time. I must say I AM NOT impressed with the workmanship of this kit. Had to make my own oil cooler and radiator brackets. The one that they sent was 1/2 inch too short. Yeah I spent 4 hours making sure I wasn't over looking something, but it just didn't fit. Now I'm stuck on the boost controller. The instructions can only be called vague at best!!!!! Damn I'm aggrivated with this whole deal. Anyway, instructions say there should be a vaccum line from the turbo to the backside of the wastegate. Nope. No brass barbs for a line on or even near the wastegate for a line. Nor are there any fittings on the turbo. There are however 2 threaded holes on the front and back of the thing with no fittings installed or even with the kit anywhere. Are those just supposed to remain open? The top and bottom have been run to the oil pan and the top to the crankcase pickup on the motror. What the crap! Starting to wonder if I should have stuck with the spray!!!!
Had to make my own oil cooler and radiator brackets.
DENNIS'S KIT HAS MORE FABRICATION NEEDED THEN THE VELOCITY KIT TO BE HONEST... BE HAPPY YOU WENT WITH VELOCITY IN THIS CASE... WITH ALL THESE TURBO KITS, A CERTAIN AMOUNT OF FABRICATION IS REQUIRED... I WAS THINKING HOW YOU WERE THINKING TO BEGIN WITH AS WELL, BUT THEN REALIZED THEY WERE ALL LIKE THAT...
The one that they sent was 1/2 inch too short. Yeah I spent 4 hours making sure I wasn't over looking something, but it just didn't fit.
BEEN THERE... I FEEL YOUR FRUSTRATION...
Anyway, instructions say there should be a vaccum line from the turbo to the backside of the wastegate. Nope. No brass barbs for a line on or even near the wastegate for a line. Nor are there any fittings on the turbo.
I WENT WITH THE MULTI-STAGE BOOST CONTROLLER SO MINE WILL BE SETUP A LITTLE DIFFERENT THEN YOURS, BUT I CAN'T THINK OF WHY YOU WOULD BE TRYING TO PLUG INTO THE TURBO... I THINK YOU MAY HAVE THIS CONFUSED AND IT ACTUALLY GOES SOMEWHERE ELSE, SHOULD LOOK AGAIN... (I HAVE NOT DONE THE 2-STAGE CONTROLLER, SO I CAN'T BE POSITIVE, JUST TRYING TO HELP... :d)
There are however 2 threaded holes on the front and back of the thing with no fittings installed or even with the kit anywhere. Are those just supposed to remain open?
YES, NOTHING GOES THERE.... :d
The top and bottom have been run to the oil pan and the top to the crankcase pickup on the motror. What the crap! Starting to wonder if I should have stuck with the spray!!!!
RETURN LINE FROM BOTTOM OF TURBO GOES TO NEW HOLE YOU HAVE TO DRILL IN OIL PAN. TOP LINE GOES TO SIDE OF ENGINE... (I COULD TAKE A PICTURE IF THAT WOULD HELP, CNA'T THINK OF THE NAME OF WHERE IT GOES...)
Post all your questions, issues, and any details you can... I think I can help you out a bit here.... If you cold post the hose diagram to the 2-stage boost controller, i may be able to help there too....
CLoud