mayywayy33
Registered
I post a thread about kaw 1400 rims and I got alot of responds about bolt pattern but if you put a sprocket on the rim that fit wouldn't the rims fit on my Busa?
Kaw 1400 rims
- Thread starter mayywayy33
- Start date
Well, if you change the Wheel, Sprocket Drum and the spacer, along with wheel bearings, retainers and maybe axel (I don't know if the 1400 axel hole is the same size). Then see if everything lines up, then maybe it will work. You might just have to buy the entire ZX 14's rear wheel assembly. It can be done. And very simply, IF everything needed is a duplicate swap, which I doubt. It would just take some time, measurements and compair parts. Might work ? But I doubt it would be as simple as just swaping out wheels.
DevilDawg1
Registered
Yes it would work like a Ford wheel on a Chevy.
Can it be done? - Yes.
But is your pocket book deep enough for all the modifications (if any).
It could be a direct swap, but that is not likely to happen.
Good luck and post up what ever it takes to make it work.
Can it be done? - Yes.
But is your pocket book deep enough for all the modifications (if any).
It could be a direct swap, but that is not likely to happen.
Good luck and post up what ever it takes to make it work.
Similar threads
