hot bodies oversize intakes

[notright]

I recentley had the good fortune to customise my gen 2 after mistaking a straightaway for a barbedwire fence. All of the front and side plastic was fubared. After the plastic was replaced I had the shop add the hotbodies oversize intakes. now I have an alingment issue on the right side fareing where it mates to the nose cone and I have to keep poping the under pinning back in to get it to mate back up close ,not perfect. The left side looks perfect. The custom shop it is because the intakes bow out the nose cone. I am also concerned about this comeing lose at mach speeds . Any thoughts??

 

[Mojo]

I can't answer your question but to the Org.

 

[Scar]

I'd contact Matt at the manufacturer.

Tell him I sent you.

matt@hotbodiesracing.com

Let me know if you have any problems.

For real.

 

[Scar]

to the .oRg. Great problem-solving skills...

 

[macon454]

to the org.

 

[TruWrecks]

I would like to find out if they actually are beneficial or not. I like the look, but the factory turn lenses are designed to help direct more air into the duct at speed.