for those who like it hot

[heykenny]

Polaris ATV heater kit pt #2875344..  work great,cool little switch.....  these are warmer than I'm used to,where most have warm and a little warmer, these have HOT! and "cant hold the grips"..  I only need low for MX gloves down to 'bout 40 degrees.

 

[NightCrawler]

Nice, but we don't need that here in Miami.

 

[Smugly]

But I need them in Canada. The best accessory I have put on my bike to date.

 

[TA_GunSurgeon]

I rode a Goldwing that had heated grips and they are awsome when it's cold out.

 

[heavybusa]

cool, what grip are you using?

 

[Smugly]

Generic snowmobile heating elements. Under 30.00/canadian

 

[heykenny]

cool, what grip are you using?

stock grips.. went on over the elements no problem.. did grind the sharp ridges off the plastic throttle tube,so there wasn't anything sharp to fuss with the heaters

 

[heavybusa]

Thanks.

 

[BigBSBusa]

Nice, but can we get some more pics of the setup?

 

[heykenny]

heres a pick of the kit, the switch pictured is a little different than mine, and a generic link... picks of the bike won't show anything different than stock,except for a little wire leaving the end of the grip
http://www.polarisofdaytona.com/eshoppr....ERS.htm

 

[BigBSBusa]

heres a pick of the kit, the switch pictured is a little different than mine, and a generic link...  picks of the bike won't show anything different than stock,except for a little wire leaving the end of the grip
http://www.polarisofdaytona.com/eshoppr....ERS.htm

Would still like to see the post install pics.

 

[JusPlaynBob]

I've got the Kimpex grips.
$29.00 at Canadian Tire.

Trouble is the left side doesan't get a warm as the right.

The plastic throttle acts as an isulator from the metal handle bar.
A little metal duct tape around the left bar first, will make it nice and toasty.

 

[heykenny]

okay.. heres one side

 

[heykenny]

and the other

 

[BigBSBusa]

Thanks, any reason the wire on the clutch side appears more hidden? Just the angle of the pic?

 

[heykenny]

clutch side doesn't rotate.... throttle side has to have some slack so the grip will still turn!... It is a bit of a balance between good looks and making sure there is no stress on the wiring,or throttle restriction.

 

[BigBSBusa]

clutch side doesn't rotate....  throttle side has to have some slack so the grip will still turn!...   It is a bit of a balance between good looks and making sure there is no stress on the wiring,or throttle restriction.

Didn't think about it, but makes sense.

 

[bigoltool]

heres a pick of the kit, the switch pictured is a little different than mine, and a generic link... picks of the bike won't show anything different than stock,except for a little wire leaving the end of the grip
http://www.polarisofdaytona.com/eshoppr....ERS.htm

Looks just like the Dual star kit. Had that kit since I got my bike and love them.

link

 

[Mike.P175]

Nice mod the switch looks factory

 

[webbashl]

I have been wanting to do this all winter!!