ltwgs
Registered
I've been reading through a lot of threads since joining 2 days ago, and it's all been very helpful up to this point. I bought this Gen1 (my first busa) with the headlight conversion completed, to a degree, but as Willie G pointed out they emit a dull soft yellow that cannot be easily distinguished on a sunny day...(nearly worthless at night)...Per what I've learned by the Org's teachings, I removed the front fairing and just one of the lamp assemblies to seek out replacement/improvement parts. Would someone explain to me this bulb setup - is it a factory wiring and bulb assy in an aftermarket housing or what? I'm missing those clips on the backs, several screws don't match as they should, and the lenses are either damaged on the inside or just shoddy.
Seeking replacement parts is the final issue, after visiting the Pyramid Plastics site which doesn't seem to sell the light housings/lenses separately from the conversion kit. Can I get aftermarket bulbs with the wires and connector since these were soldered together?
Pics...
1. Overview
2. Bulb Housing - rear
3. Wiring Assy
4. Bulb Housing - top
*the unit I pulled was the cleanest of the two, the other having rust and burn damage in key spots
Seeking replacement parts is the final issue, after visiting the Pyramid Plastics site which doesn't seem to sell the light housings/lenses separately from the conversion kit. Can I get aftermarket bulbs with the wires and connector since these were soldered together?
Pics...
1. Overview
2. Bulb Housing - rear
3. Wiring Assy
4. Bulb Housing - top
*the unit I pulled was the cleanest of the two, the other having rust and burn damage in key spots