The muffler mount location is different between gen 1 and 2.
The passenger peg exhaust mount holes are in a different location. About 3" further forward on gen1.
The head and engine are externally the same. It will bolt to the engine.
You would have to make a small bracket/extension to bolt up the muffler.
Basically a roughly 3"×1" rectangle with a bolt hole in each end. Thickness depending on material strength.
Okay I can deal with that. What about underneath the engine. I know on my Gen1, there was an interference issue that a small dent(that you couldn't see) took care of.
Okay I can deal with that. What about underneath the engine. I know on my Gen1, there was an interference issue that a small dent(that you couldn't see) took care of.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.