I have this alarm with remote start and engine disable capabilties...i just looked at the wiring diagram and location of the wires...if i tap a wire into the starter relay will it be the say as taping a wire into the starter switch? If not where in the wiring harness is the best place to tap into the starter button? Another question for the ignition switch its self where is the best place to tap into the wires for that? thanks
alarm woes
- Thread starter him
- Start date
1127 TO 1299
Registered
can't help you on that but I can help you bring that question to the top
Can't help much there. Just got done installing my Scorpio. Did you try looking over Ice's write-up? Maybe it could help you out with the starter disable.
Exact same wire that I used. Worked like a champ.
TruWrecks
Banned
Don't unplug it. You'll have to cut the Orange/White wire and connect the relay "into" it's path (the plug side to one side of the relay, the other side to the Orange/White wire that's cut). My pic looks that way because I soldered and wrapped all of my connections. It's more work than crimps, but it's much more durable.
Mine worked. Not exactly sure what is going on, you don't have the Scorpio, right?
drag_on77598
Registered
i honestly don't know, but i will tell you i complement you for doing so i have a scorpion alarm and a lo-jack. and i must say that the scorpion is bad ass!!! i tested it at a mall and the remte actually worked while i was in the center crt of the mall. it also comes with a feature to shut it off, just in case you see the ####### riding off, to bad a bat doesn't come with it.
Do any of these alarms help find the bike when they load it into the back of a van? I lost one that way already.
