Re: Busa with Fuel Pump issue and battery is drained after being parked for a few day
I located one issue with the battery drainage. The starter relay had over 12 voltages on the B terminal and M terminal when the bike was turned off. The M lead goes to the Positive terminal on the battery and...
Re: Busa with Fuel Pump issue and battery is drained after being parked for a few day
I pulled the fuel pump relay and check the voltage at each wire. Here are the readings:
R/BI = 12.51 volts
Y/R= 12.46 volts.
O/W= 12.18 volts
Y/ B = 7 volts
Re: Busa with Fuel Pump issue and battery is drained after being parked for a few day
I bought a circuit tester and remove the negative cable from the battery. The circuit tester light turned on, then I remove the fuse for the fuel system and the light turned off. The fuel system is the...
Re: Busa with Fuel Pump issue and battery is drained after being parked for a few day
Thanks, I will have my battery checked out. Just a minute ago, I started to pull fuses and when I pulled the 10 AMP fuse for the fuel system, the gauges bounced and the multimeter was reading 12. 51 volts and...
Re: Busa with Fuel Pump issue and battery is drained after being parked for a few day
I will begin to check the injector/pump circuit. The injectors has its own wiring harness that connects to the main harness, right? Where are the grounds located on this beast?
Re: Busa with Fuel Pump issue and battery is drained after being parked for a few day
The latest status so far: I disconnect the ignition switch to see if the battery will continue to drain while parked. So far, after 24 hours the voltage decreased by .01 volts, let me explain, I tested the...
Re: Busa with Fuel Pump issue and battery is drained after being parked for a few day
Thanks for the codes. I have one question what is the power supply to the injectors? This is for codes 32.,33,34,35.
Re: Busa with Fuel Pump issue and battery is drained after being parked for a few day
The problem started at separate times. The battery issue has been an ongoing problem. In two years, I have replace the battery twice, so I decided to purchase a charger because I was tired of going to a bike...
Re: Busa with Fuel Pump issue and battery is drained after being parked for a few day
The problem started at separate times. The battery issue has been an ongoing problem. In two years, I have replace the battery twice, so I decided to purchase a charger because I was tired of going to a bike...
Re: Busa with Fuel Pump issue and battery is drained after being parked for a few day
I disconnect the ignition switch to see if its the culprit. The battery reads 12.52 volts right now. I will leave the battery connected while the ignition is disconnected to see if the battery continues to...
Re: Busa with Fuel Pump issue and battery is drained after being parked for a few day
I attempt the drain test and remove the negative cable. When I connected the negative prong of the multimeter to the cable and positive to the negative battery terminal. Upon touching the terminal, a click...
Re: Busa with Fuel Pump issue and battery is drained after being parked for a few day
I purchased the bike used and I was told an alarm system was installed at one point. How do I track down a shortage in the wiring? Where must I begin? One time, I suspected a problem with the charging system...
Re: Busa with Fuel Pump issue and battery is drained after being parked for a few day
I used a battery charger called speed charger from Autozone. The charger has an option to set it for 2AMP small battery. According to the instructions, the charger will shut off when a battery is charged...
Re: Busa with Fuel Pump issue and battery is drained after being parked for a few day
I charged the battery a few times and after installing the battery after charging, within a few days the battery is low and not able to start the bike.By the way, this is my third battery in two years. I have...
Busa with fuel pump issue and battery problem
Hello Everyone,
I have an 03 Busa with a few issues:
After riding the bike for about 30 minutes, a fault code of 32,33,34,35 pops up. What must I do to resolve this issue. I have a Clymer manual, but understanding what to do to stop this...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.