Recent content by rb3221

I think I may have to go with the Port Fueler kit. I seen that schnitz racing was making one with a bit better injector angle, but it looks like they no longer make it. I will also look at the gen2 TB's.

I was looking at the "port fueler", but I was seeing mixed reviews. Car guys think their great but some of the bike guy don't. Controller wise I don't care about theirs, as the bike has a stand alone system and it will run the extra injectors.

Chris, Plenum is not the problem, the problem is there is not enough room between it and the chassis rails so I was looking for something that went in to the ports and worked. Rick

I’m looking for Secondary injectors to go on a Gen 1 hayabusa turbo. The problem I have is I cannot fit them in to the plenum. What is around that works?

Thanks I would give it a try, I think they are the same. Rick

Anyone got a DXF or drawing for a one peace exhaust/manifold flange for a gen1 ?

Can anyone tell me if the Vance & Hines sidewinder are any good? I'm looking at a set for a drag bike I'm putting together. Or is there a better sidewinder systems out there?

Hi All, Has anyone had this happen, I have a 00 busa it is surging bad down low and at idle and I have been though everything (and I mean everything). What I have found is it’s putting in way to much fuel and you can not lean it up, if you high idle the bike on the stands at say 2500 –...

Punisher, Any luck on the Grommets ?

Punisher, Any luck on the Grommets yet?

Thanks that will be good. Rick

Punisher, did you get the email I sent you about the grommets??

Punisher, PM sent

I need some rubber grommets for going around the hole for the sliders, but I also need them USPS to Australia. I know someone on Hayabusa.org was selling them

Did you get any more grommets ?