Recent content by BEERMONEY

She runs like a dream now. Small little quirky issues but she runs brand new :)

Will that fit a gen 1?

You think that front brace Berlin posted would actually prevent that from happening again? @sixpack577

So here’s the pictures, as stated first one cracked by the front, here’s the second brand new part now @Berlin Germany @sixpack577 @michael parris heuberger

Had a spun rod bearing when I bought it, did hella trouble shooting all the way from clutch to tensioner, tore her apart and found cylinder number 3 spun. But I bought the bike and it only ever had the rear tail plastic, trying to find the side fairings for it aswell!

So I searched the forums trying to find out what’s the deal with my front sprocket cover cracking twice now. Just did a fresh rebuild following the pdf step by step and even had the power copy. Twice now my sprocket cover has broken such to the point I’m going to order a billet one. 03 busa...

Finally rebuilt my whole busa, looking for some side plastics, anybody have a set of left and right side plastics for sale? I’m located in southern Cali. Not far from LA. Closer would be preferred but some of those eBay plastics are outrageously priced or cracked. Couldn’t care less how they...

So these are the few tool items I went and grabbed and already have the plastiguage, waiting on the new oem connecting rods to come in. But I have a new crank I'm throwing in, they look pretty immaculate and the old one will be sent off to get done once the bikes running. As it was the crank...

Okay, but should I order one of each bearing? I got the internal bore Guage coming to mic them all out with. Do I just take the measurements of them without any bearing internally, and then mic the cranks subtract the small number from bigger and divide by 2 to find the correct color coded...

So got an 03 busa for a steal of a deal, found out it had a spun bearing, tore the whole motor apart, got the new crank already, and new connecting rods on the way. Next couple steps I'm just a little curious as to how to get the correct color coded bearings for the main bearings and connecting...

What do you have in stock and where are you located? #spunbearing. Won't be able to look at the carnage for 2 weeks but when I do I'll know just hod bad it is, sounds like it's just one though

I'm also close to LA with the same issue sadly any luck and what did you end up doing?

When I did the original pil change, I saw some metal shavings, very minimal and no chunks, nothing out of the normal. It was a bit more than one would normally see, but wasn't anything crazy. For a bike that ran fine 3 years ago, to now just back up and running, I was expecting some metal...

Probably gonna bite the bullet and have the shop look it over ‍

nothing terrible vibrating other than when it clanking you can feel it vibrate throughout the bike, I've tried touching everywhere when it's happening and nothing vibrating more than anything else.. and nothing abnormally wrong with it.