04LE
Registered
So I attempted to install the brock's clutch mod (2008), I put took the old unit out replaced with the brock's unit. Did not use the spacers since i couldn't get the stock bolt to reach with the spring to the brock's unit. Put it all back together did the oil change at same time. Now when i started her up on the rear stands i can shift to every gear but it doesn't seem like grabbing the clutch lever takes the drive away from the rear wheel. Anyone know what I did wrong?
https://www.hayabusa.org/forum/gen-ii-busa-information/121630-brocks-clutch-mod-cushion-kit.html
9th picture in the attached thread my bolts around the springs are one piece. There wasn't a piece that screwed into the brock's piece and then i would screw into that. Don't know if thats because that kit was the mod and cushion or what.
Any help is much appreciated!
-Tom
https://www.hayabusa.org/forum/gen-ii-busa-information/121630-brocks-clutch-mod-cushion-kit.html
9th picture in the attached thread my bolts around the springs are one piece. There wasn't a piece that screwed into the brock's piece and then i would screw into that. Don't know if thats because that kit was the mod and cushion or what.
Any help is much appreciated!
-Tom