Bubba Zanetti
Registered
Hi,
I've read lots of threads on here about adding an oxy sensor to US bikes, mines a Euro model (Ireland) and I've put a full Yoshi 4-2-1 system on with no bung for inserting the o2 sensor. I've no desire to go drilling the exhaust and adding the sensor as I'm sure if it was that critical Yoshi would have done that already.
How can I get the FI light to go out when I pkug out the sensor? I read somewhere that you can short out 2 of the 4 connectors with a 330 ohm resistor, but which 2?
GEN 1, 2006 btw
Cheers.
I've read lots of threads on here about adding an oxy sensor to US bikes, mines a Euro model (Ireland) and I've put a full Yoshi 4-2-1 system on with no bung for inserting the o2 sensor. I've no desire to go drilling the exhaust and adding the sensor as I'm sure if it was that critical Yoshi would have done that already.
How can I get the FI light to go out when I pkug out the sensor? I read somewhere that you can short out 2 of the 4 connectors with a 330 ohm resistor, but which 2?
GEN 1, 2006 btw
Cheers.