Working on something else





Juggler

Techie Answer Guy
Donating Member
Registered
#6
I half-way expected to see one of those V thingies with the arc, like in Frankenstein's laboratory. Sweet lookin' swingarm.
 
#7
Here are some more pics to show the details. The line is how far the tab goes into the swingarm (2 full inches)for added strength against pivot torque,most maker of Weld in extensions only make the tab 1/4 inch or so. The Arm will be drilled where the black dots are and welded there as well to add strength.
Swingarm30.jpg

This is an inside shot of the Stainless steelwell nut. It is there to be torqued down to assist is holding the axle in place for high horsepower applications. Less torque is applied to the axle adjuster bolt also when the bike is launched because of this part
Swingarm31.jpg

Front shot of the axle spacer
Swingarm32.jpg

A massive 1/2 Stainless steel bolt will be installed. No studs will be out of the rear to get injured on or to strip.
Swingarm34.jpg

Swingarm35.jpg

I believe these will be the strongest Welded in Extensions on the market. More Over and Under bracing will be added later
 

Similar threads





Most likes - Past 7 days

Latest Bikes

Forum statistics

Threads
171,148
Messages
3,050,596
Members
46,985
Latest member
White1600
Top