Woolich Racing Flashing Issue

[Gottibusa08]

I got home this afternoon, hooked to the logbox for the first time, read the map in the ecu and saved it. Came back out a little bit later, put the panels back on the bike, and threw the tank on, now it won't read or write the ecu, just gives me a set baud rate error and says unexpected or missing ecu response. Turn off ignition and reset interface and try again. Ugggh bout ready to throw a grenade under the bike and be done..

2008 Gen 2 Busa
Log Box v3
Zeitronix wideband
1441

Used to run decent

 

[Gottibusa08]

This is a new install as well. Read fine on first try, but now it won't do anything.

 

[Gottibusa08]

Fixed. Blue and brown were swapped in Molex connector. She's good now

 

[GIXERHP]

You may have the wrong ECU # loaded,

 

[Gottibusa08]

Thanks Gixer, it was actually the blue and brown wires were reversed in the connector.

 

[GIXERHP]

That will do it, it will se it but not read or write to it