Which wire harness is the fan switch on or what type of connector?

twvette

Registered
Have a '06 busa engine in a UTV off road vehicle and need to re-do the electrical connections for the fan switch and going to go to a low temp switch. Anyone know which harness has the elctrical connector to this switch as looks like a couple different ones on the cheapcycleparts.com diagrams it could potentially be on and not labeled? Or, what type of connector and where to buy? I just want the connector and the wires coming out of it essentially for a cleaner connection rather than rig it. Thanks ...
 
I am not exactly sure what you are wanting, but I do recall people using a Honda fan switch as it turned on at a lower temp. I want to say that it plugged right in.....

Hope that helps!
 
Thanks for the help. I know where to get the low temp sensor (eBay). Just need the electrical quick connect that plugs into it so I can do a clean eiring job in my custom application. Either from a stock wire harness or the type of connector to purchase.
 
I was a little confused. I purchased the Schnitz Low Temp Fan Switch HAY1028. It does indeed appear to actually be an Accord/Prelude fan switch that was used on late 90's models. Searching eBay I see ones by Contour part #37773-PT3-A01 and Beck/Arnely part #210-1650. These are MUCH cheaper than what I paid and there are other brands that appear the same.

So, what I am in need of now is the wireharness/connector that would connect to this two pin round connector on the switch. Seems like it could be a fairly standard type of connector but searched for a while now and not coming up with anything to order. I will probably stop by Honda and see if they can help me identify the harness and hopefuly I can locate one for cheap or I will proceed with connecting it up by other means.
 
I just decided to wire up with some spaid connectors that fit secure and just filled the connector with epoxy to ensure they stay put and doesnt get filled with sand, water, etc.
 
Back
Top