Where To Install Frame Sliders

[Kid_dynamite4598]

This will be my first time putting on frame sliders. When I looked on youtube I only found scrappy videos. Does anyone have pics of where they put them on their bike or a good install video?

 

[bigoltool]

Normally I would advise using the search tab in the upper right of the screen, but the board has been having a few issues of late. Resort to Google. Search for Hayabusa Frame sliders or just Hayabusa sliders and then pick the results from the org. Heres a few.
https://www.hayabusa.org/forum/threads/frame-sliders.123461/
https://www.hayabusa.org/forum/threads/frame-slider-install.123357/
https://www.hayabusa.org/forum/threads/has-anyone-installed-the-no-cut-frame-sliders.100991/

On my 03, I personally used two small round rare earth magnets to mark the fairing panels for drilling. Put one in the bolt head, put panel back on, stick the other magnet to the outer face and voila thats your center. Everyone seems to have a different preferrred method. The no cut sliders are not my fave but they preclude you having to cut holes in your panels.

 

[Mythos]

I don't have them on my busa but they are not hard to install. You may need to trim fairings.
https://www.revzilla.com/motorcycle/shogun-frame-sliders-suzuki-hayabusa-gsx1300r-2008-2015

I have seen then coming out of the side vents and those may require no fairing trimming. They probably bolt to an engine mount.
https://www.hayabusa.org/forum/threads/has-anyone-installed-the-no-cut-frame-sliders.100991/

 

[fallenarch]

I use T-Rex no cut sliders. Highly recommend this.

 

[Blacknite29]

T-Rex installed on wifeys bike. Highly recommend them for busas.