What is the Best Way To Re-install this ???





Pardini

Donating Member
Registered
Sheetrock screws, duct tape and baling wire. Not necessarily in that order.

Snagged on those pink chaps again didn't it. :rofl:
 

Pardini

Donating Member
Registered
It's actually attached to the ram air intake not the front cowl. Epoxy should hold it or a soldering iron to melt it back in place.
 

mzrsq

Busaless
Donating Member
Registered
I mounted all of mine, including the nose when I powdercoated them using a soldering iron.......Looked just like the factory.
 

Bosshound

Donating Member
Registered
DO I have to Remove the Fairing and or Front Cowl ? I was thinking about pulling it through with a Wire Attached to the Middle Somehow :dunno:
 

Pardini

Donating Member
Registered
The front has to come off. Did it come out thru the intake cowl? Maybe you could loosen the top and sneak it back in without removing everything. Take off the screen, mirrors and inners. then lift the front off the mirror mounts and pull it forward to see if there is room to get it back in place.
 

Blazing-Saddle

"Kowalski"
Donating Member
Registered
The front has to come off. Did it come out thru the intake cowl? Maybe you could loosen the top and sneak it back in without removing everything. Take off the screen, mirrors and inners. then lift the front off the mirror mounts and pull it forward to see if there is room to get it back in place.
This is probably your best bet....
 

Acehole

The crowbar!
Donating Member
Registered
Nose off and use the soldering iron. Good luck. Oh and wash gently next time!
 

Sannosuke

Registered
... I must confess. did the same thing last year but just not to this extreme, it's still 90% attached.
 

Similar threads





Latest Bikes

Forum statistics

Threads
171,832
Messages
3,071,089
Members
47,252
Latest member
Steve kilmer
Top