What Did You Do To Your Busa, Today?

Got the old out & the new rear bearings in. Got going putting them in & forgot to put center tube in then had to figure how to pull one out then redo. Duh!

20190102_143327.jpg
 
Does your center tube flop a bit?
Mine seems to be looser than I remember
No flop think everything centers off cush drive side 1st. Did you press these in? Do by hand with old bearing on top of new with a metal hammer. No damage & you can hear a different tone when it hits bottom. Check you tube replace hyabusa rear bearing. Fit is tight. May have to use but of screw driver to center tube.
 
Back
Top