Water getting past ignition coils

[Quiksilver]

Hello everyone i have a 2002 turbocharged hayabusa with 11000 miles. When it rains or when i was my bike i have water that gets past ignition ignition coils and it sounds like a vtwin and runs very rough. It is under the house and i take care not to get alot of water in that area when washing as much as possible. I have removed the coils and i can see the water on coil 1 2 and 3. It feels tight when i put them on and i cannot see any debris that would cause it to not seal properly. I was told its a rcc style intake? Sorta small and doesnt cover uP the coils at all. Not sure if i should try to put orings, some kinda shield or some type of sealant. Would hate to have to buy new coils to fix. Thanks everyone

 

[GoldenChild]

I have several mint sets of coils..

 

[lankeeyankee]

Trying using some delectra grease when putting the wires back on and then use some rtv silicone on the outter of the boots to seal em.
Even get a balloon and zip tie the end to the wire.