how do i adjust the trottle position sensor without the special tool to switch ... what two wires onj the dealer plug can i jump to get my c-00 display
Still not sure of my dealer plug
I have no plug with just 2 wires
I have and ecu editor are these the same plugs I plug that into
If so one is black and has 6 wire the other is White with 4 wires
I also have a manual which I can't seem to find these plug in the wiring diagram
Still not sure of my dealer plug
I have no plug with just 2 wires
I have and ecu editor are these the same plugs I plug that into
If so one is black and has 6 wire the other is White with 4 wires
I also have a manual which I can't seem to find these plug in the wiring diagram
On the left side panel, there's a link for Dealer Mode and TPS adjustment.
Here's a link for a 2007 GSXR1000, which I believe is the same location. Take a short wire, about three inches long...crimp/remove the ends on both sides so the wire is exposed and insert it into the 2 pins it says. It should be inserted into the holes where the White/Red AND Black/White wire end. Your engine must be running and the FI light must be on in order to see the C code.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.