Ti-Force with O2 bung??
- Thread starter dr.nick
- Start date
Check with orient express.
Local weilding shop could weld a O2 bung in for you.
Thanks guys,called orient express,Skip say's that Ti mid
pipe with 02 bung was discountiued 1 1/2 years ago
because it was to expensive and no one was interested
I can get a 02 bung with threads for $100
,but to
find a welding shop that does Ti in my area is difficult
because you need Argon gas in an enclosed booth(Ti
during welding process can not be exposed to O2)
pipe with 02 bung was discountiued 1 1/2 years ago
because it was to expensive and no one was interested
I can get a 02 bung with threads for $100
find a welding shop that does Ti in my area is difficult
because you need Argon gas in an enclosed booth(Ti
during welding process can not be exposed to O2)
True, I am taking welding myself at the union hall.(dr.nick @ Oct. 12 2006,08:19) Thanks guys,called orient express,Skip say's that Ti mid
pipe with 02 bung was discountiued 1 1/2 years ago
because it was to expensive and no one was interested
I can get a 02 bung with threads for $100,but to
find a welding shop that does Ti in my area is difficult
because you need Argon gas in an enclosed booth(Ti
during welding process can not be exposed to O2)
Not many can weld TI or is setup to. Best bet would be to make a few phone calls and see if anyone local could before sending it out.
Like you said there might not be many welding shops in NY.
Isn't there a plug so it wouldn't trip a code to block the O2 sensor on a busa equiped with one?
Would that be any easier route?
Would that be any easier route?
Yes sir.(dr.nick @ Oct. 12 2006,09:58) Pipefighter,I don't think busa's come with an 02
bung(not yet),and if they did,that would be mounted on a stock header.Ed
CA and Euro model Busa's had O2 bungs and sensors from factory.
Didn't know if you had one of those models.
I'm on the same page now.
Still try and call around some.
Might actually find one nearby.
Similar threads
