Patient ? be patient he says damn I have been waiting since 99
Not sure on the join date ? I must have logged in then when I first got my 99 Busa .................
I was wondering if anyone has done a throttle body synch on the Gen 2 without using the SDS tool ? And the end results ? Cheers
It's an ok system (ISC) ............. but as usual technology complicates servicing. This applies to 08 and on Busa's basically without this or an SDS unit you cannot get an accurate reading from balance gauges when synching throttle bodies. At $73 US it's a lot cheaper than an SDS and it's available ...........you CAN buy it
WAG >>>>>>>>>>> pleasure
Floyd what you speak of is the "pair" system and Gen11 still have this also. The "ISC" is idle speed control and it basically is an electric stepper motor that regulates air flow at idle and electronically adjust idles speed
In the Gen 11 the throttle plates are completely closed at idle. ICS is controlled by the ECU which with information it gathers from other sensors tells the ICS how little or much air too allow for correct idle speed given the parameters at that time.
Now I'm gonna have to buy a new bike!
Sounds like it is more difficult but not impossible to sync the throttle bodies without some special device. I'm gathering that dealers would have it, but it is difficult to find an alternate source and buy one?
I don't know if I would be up for syncing throttle bodies anyway. Sounds like trying to adjust 4 carburetors on an old bike.
Your correct ................. right tools are the key .............. and made frustrating when you can't buy what you need to do the job. Besides I don't trust others to do the job
Welcome to my garage