donpearsall
Registered
What is the best signal to use for an RPM input to various devices? I am installing a Zeitronics Air/Fuel monitor and it wants a 0-12v Square wave tach signal to monitor RPM.
The 'Busa schematic says there is a Yellow/Blue tach out wire, and additionally a white/blue wire that is the #1 coil primary wire.
Which would be best to tap into? Also, does it degrade the signal if more than one device is tapped into the same wire?
Thanks
Don
The 'Busa schematic says there is a Yellow/Blue tach out wire, and additionally a white/blue wire that is the #1 coil primary wire.
Which would be best to tap into? Also, does it degrade the signal if more than one device is tapped into the same wire?
Thanks
Don
