Stock swingarm arm length?

BigRod1300

Registered
What is the stock swingarm length of a GenI from center of pivot bolt to center of axle???????? Playing around in the garage on tucking the 330 up into the tail....but I have no arm to compair to see what stretch I found is the sweet spot. My measurement I like is 27-28 " center pivot to center axle.

Thanks, fast responce would be great!:beerchug:
 
Pic of course...forget my invisible swingarm or method of getting the 330 into that spot for the pic:laugh:

DSC00847.jpg


DSC00848.jpg


DSC00849.jpg
 
I like where you have it mocked up at. Looks better than hanging out so far out the back. That looks about 4- 5 . Im 6-6 1/2

Busa 350.jpg
 
Last edited:
Cant help you Brother but it looks like you have it about 5 1/2 to me

Maybe less
 
i have a stock gen2 arm laying on the floor i can measure if that will help?
 
Been told now that stock is 22-1/4" so at 27-28" ( 27 in pic ) that would be at 6+ over.

Yea I still like it the way it was at 9 over but....REALY feeling this in the pic. The way I was rocking the 330 at 9 over, imagine what I can do with it short at 6 over:whistle:! Prob have lots better launch at the trac too helping with weight transfure.
 
Back
Top