Seat Hump Mod.......

delboy

God save the Queen.......
Donating Member
Registered
So I sat down on the weekend with my seat hump between my legs, and made the cut-outs (checked if a black seat hump was available on Ebay first). Great result, 2 hours later perfect fit. Now can hold on to something when lifting the Busa onto the paddock stand.

Checked with my Aerodynamic's guy Cetin, he said that the effects would be negligible.

OK, still have chicken strips  
biggrin.gif


paint work must be good, as you can see your face in it
jump9.gif


seathump1.jpg
 
just curios mate i have got to get anouther hump coz i tried putting kanji logo into mine and wrecked it. how do you measure the lenth of where to cut the hump and what did you use?
looks very nice job well done
beerchug.gif
 
Probusa, quite simple mate.
1) Bolt-on grab rail.
2) Place hump on top in approx the right position for it to lock down.
3) Using masking tape, mark the edges of the grab rail.
4) Protect hump at all times, I used an old pillow case.
4) Check the depth, I started at 12mm, again mark with masking tape.
5) Using a 6mm drill, drill hole approx 3mm from marked profile.
6) Rough-out basic profile with junior hacksaw, best not use any other power
   device unless you have a dremmel.
7) Hand file to profile and trail fit, keep removing material and trail fitting until it clips into place.

It will take some time, do not rush it and you will get a good job.
beerchug.gif
 
great seat hump came yesterday i have marked it all up will get dremmal out and start tomorrow
beerchug.gif

will take me time and keep you posted on the outcome
super.gif
 
Back
Top