Thanks to Rick at Rick's Custom Cycle in Garden City, MI who let me install this on his 08 busa and make sure it worked, and it did
A few pics, install was cake, take a paper clip and push the white dummy plugs out of pins 25 and 28 out from the front of the connector through the back. Then just insert the 2 pins, the green wire i had was 22 gauge (sorty flimsy) and i had to use a small screw driver to push it all the way in, the 20 gauge brown wire i inserted with just fingers. no need to remove the back cap or anything, just insert until it clicks, easy cheesy!
We removed the battery to get the ecu connector up further, and pulled the barometric pressure sensor off its little base bracket so i could get at the yosh and sds. I would say maybe 5 minutes if that to wire in the tiny 2 wire harness. We unlocked the yellow lock in the yosh plug, to insert my green and brown wires into proper locations, then put the lock back on.
To start with we flashed 12,000 RPM limiter hardcut only, no gear limiters, i think that was it.