Risers

TheEarthdog

Donating Member
Registered
I am going to install a set of risers and thier documentation says I should relocate the Choke/Idle Adjust cable. Any suggestion on the cleanest route?
 
Disconnected it at the throttle bodies and passed it to the left of the steering stem under the tank in between the front mounting bolts.

I covered the cable with a piece of vacuum tubing cut lengthwise as it passed under the tank.
 
I would install the item first...then see if relocation is even necessary.
I installed the reaper version...none necessary. I will be installing a genmar this weekend, and again measure before making any relocations.

much depends on exactly what hieght you went with.
 
I would install the item first...then see if relocation is even necessary.
I installed the reaper version...none necessary.   I will be installing a genmar this weekend, and again measure before making any relocations.

much depends on exactly what hieght you went with.
Where did you buy the Reapers?
 
Personally, I got mine off eBay...
but there is a thread on the SH.org site for the people that make them:


If you want, I can PM you when I decide which version I decide to keep....I usually only ask what I paid...and I never pay retail!....hehe
 
Personally, I got mine off eBay...
but there is a thread on the SH.org site for the people that make them:


If you want, I can PM you when I decide which version I decide to keep....I usually only ask what I paid...and I never pay retail!....hehe
Thanks, that would be great. When are you planning on selling them?
 
Back
Top