RidersNation surfaces!!!

RidersNation

Stud Muffin
Donating Member
Registered
Hey there!!!
Just checking in and hope all is well with you guys.

Moto GP was a little better. I saw some of you on the Row Sat night.

Anyways,
Tonight I went for a ride and fouled number three plug and then as I was inside, I looked down the throttle bodies and into the valves, which is pretty cool if you have never done before, and noticed all the valves in each cylinder on the left sides were fouled with black bubbly buildup.

Any one ever seen this before? injectors bad maybe? Also I noticed grime only on the front of throttle body number three.

I have switched around the plug coils every so often but number three seems to foul after a "chug (keepin it below 2500 rpm) ride".

PLUS I noticed this too. My bike when unloaded (flat ground or slightly down hill) at 2500-3500 chugs bad like the tranny is done. I even ran it on the stands in gear and there is a noticeable miss. New chain and sprockets. But it won't smooth out unless there is a load on it. I have a full Micron system, Marble mod and PCII.

Thanks for any help.

RsN
(Roy)
 
Check to make sure all the vacum lines are in the right place. I'm not sure this is the problem, but its a start.
 
Back
Top