Mythos
Registered
I just finished my end of winter dust wipe/bolt check/fairing polish and I am reinstalling the side fairings-- WTH? There is a projection on the inside of the fairing that looks as though it should push into a rubber grommet that would plug the ram air tube. There is no grommet there as you can see from the photo--just a hole in the ram air tube that the projection aligns with. Same situation down lower, I see a hole in the side of the frame that aligns with a fairing projection but no rubber grommet.
There is one rubber grommet to accept the downward pointing projection that pushes into the top edge of the frame. Also one horizontal ptrojection/rubber grommet way down at the crankcase level. Are there supposed to be other grommets at the ram air tube and frame?
There is one rubber grommet to accept the downward pointing projection that pushes into the top edge of the frame. Also one horizontal ptrojection/rubber grommet way down at the crankcase level. Are there supposed to be other grommets at the ram air tube and frame?